Post new question
Question
Reply
 
Top Student
Posts: 7
Member Since: ‎12-11-2016
Message 1 of 2 (377 Views)

No data after calibration

I am using David 5 with a Point Grey Flea 3 camera. I was able to successfully calibrate the panel (checkerboard pattern was projected perfectly). However, when I went to actually scan an object, I did not get any results. Usually a black screen, or perhaps one large triangular polygon.

 

Has anyone encountered this problem before? I did check my result filtering and both are disabled and set to 0.

 

Any help would be appreciated.

 

Thanks

 

Vince 

Reply
0
Highlighted
Teacher
Posts: 76
Member Since: ‎10-31-2016
Message 2 of 2 (349 Views)

Re: No data after calibration

Is your object too dark, or the scene does not have enough light? Red sinus line is correct between two blue lines?

I am an HP Employee

**Views expressed are my own, no one else would say such drivel**
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation