Question
Reply
 
Highlighted
Top Student
Posts: 4
Member Since: ‎09-10-2009
Message 1 of 4 (7,336 Views)
Accepted Solution

HP ProDesk 600 G1 - unable to boot with USB

Hello,

 

I received a new HP ProDesk 600 G1 yesterday and haven't had any luck getting it to boot to an USB flash drive or external USB hard drive.  I normally install our corp image (Win 7x64 Enterprise) via USB.  In setup the USB flash and USB HD are detected, but no matter what I set in the boot order when selecting F9 for boot options the USB device is not available.


 

Suggestions?

 

Thank you....

Reply
0
Accepted Solution

Re: HP ProDesk 600 G1 - unable to boot with USB

Problem solved.  In the Bios under Secure Boot Configuration - Legacy Support, i changed to Enabled.

For Secure Boot I changed this to Disabled.

View solution in context
Top Student
Posts: 4
Member Since: ‎09-10-2009
Message 2 of 4 (7,330 Views)

Re: HP ProDesk 600 G1 - unable to boot with USB

Problem solved.  In the Bios under Secure Boot Configuration - Legacy Support, i changed to Enabled.

For Secure Boot I changed this to Disabled.

Honor Student
Posts: 2
Member Since: ‎12-02-2014
Message 3 of 4 (4,376 Views)

Re: HP ProDesk 600 G1 - unable to boot with USB

Is there something more?? It still will not boot. Even after I hit F9 and I get the boot menu, I choose legacy and none of the choices will allow me to press enter..

Honor Student
Posts: 2
Member Since: ‎12-02-2014
Message 4 of 4 (4,372 Views)

Re: HP ProDesk 600 G1 - unable to boot with USB

Got it. The second part is to go back into setup. Go to Storage, Boot Order, then choose F5 to disable UEFI Boot Sources.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation