Question
Reply
Intern
Intern
Posts: 87
Member Since: ‎11-15-2014
Message 1 of 4 (358 Views)

HP Prime Units: KWh not recognized

I tried to make a Killo-watt-hours unit number with the menus:  enter number, Units->Energy->KWh.  However, the calculator just gives me "Syntax Error".  If I try again with using the prefixes "k" then Units->Energy->Wh, then it accepts the entry.  It seems like there is a typo in the source where the "K" should have been a "k".

 

Also, it was anoying to after using the Prefix menu, have to go back thru to the units desired.  It would be nicer to not have the menus exit complete but allow just going to the other from the main menu.  Or maybe better have a Prefix selection menu on every bottom units menu so that one could select the prefix and immediately select the unit.

Reply
0
Grad Student
Posts: 231
Member Since: ‎02-04-2014
Message 2 of 4 (320 Views)

Re: HP Prime Units: KWh not recognized

Good catch!  You are right: The "K" in "KWh" should be "k".  Thankfully it'll be very easy for HP to fix that bug in the next upgrade.

 

I like your suggestions regarding the prefix menu, which is currently awkward.  Let's see what HP does with this one.

 

-Joe-

-Joe-
co_ Tutor
Tutor
Posts: 10
Member Since: ‎01-05-2014
Message 3 of 4 (285 Views)

Re: HP Prime Units: KWh not recognized


davetheguru wrote:

It seems like there is a typo in the source where the "K" should have been a "k".


It's not a typo, kWh it is the correct form.

KWh would mean Kelvin*Watt*hour, therefore

the syntax error.

 

Co

Highlighted
co_ Tutor
Tutor
Posts: 10
Member Since: ‎01-05-2014
Message 4 of 4 (281 Views)

Re: HP Prime Units: KWh not recognized

Sorry, now that i turned on the HP Prime, and I see the menu
I understand what you mean. It's certainly
a typo! :-)
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation