Question
Reply
 
Student
Posts: 1
Member Since: ‎06-17-2013
Message 1 of 2 (408 Views)

Ipaq rx 3715 need to reset?

Hello
I have a problem with my Ipaq rx 3715 when I lit a stick appeared blue and not load all stayed in the middle and then put was returning to stay well all night and the next day would not start or stay loaded and well and try and put in the reset button and still have told me that you do the hard reset but did not understand why the two buttons on the left and the right so I could not.
What could you do?

 

 

 

P.S. This thread was split off from other thread,moved from Printing and Digital Imaging > Printers - Designjet & Large Format to Handhelds - iPaq, edited subtitle from 'Re: http://forums11.itrc.hp.com/service/forums/bizsupport/questionanswer.do?threadId=602485' to ' Ipaq rx 3715 need to reset?' -HP Forum moderator

Reply
0
Highlighted
Top Student
Posts: 8
Member Since: ‎11-09-2009
Message 2 of 2 (391 Views)

Re: Ipaq rx 3715 need to reset?

A hard reset will clear all programs and data.

To perform a hard reset -

1. Hold down the Mobile Media button (on the far left) and the iTask button.
2. Then press down the reset button with the styles for a few seconds until the screen goes dark.
3. To turn on your HP iPAQ after your hard reset, either press the reset button again, or plug it into an AC power source.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation