Error 21:10 After Belt Change
Replies (11)
Top Student
Posts: 5
Member Since: ‎06-11-2014
Message 11 of 12 (266 Views)

Re: Error 21:10 After Belt Change

Thanks again for the help.


I removed the print heads and restarted. It stuck in the same place and threw the same code. (86:01)

I also restarted the plotter without pulling the carriage out of the service station. The carriage moved normally out of the service station on its own but then got stuck in the exact same place. It seems like the carriage is somehow getting stuck on the service station. I may try to clean the bottom of the carriage when i have some time.



Distinguished Professor
Posts: 2,958
Member Since: ‎01-17-2009
Message 12 of 12 (257 Views)

Re: Error 21:10 After Belt Change

Did you check the encoder? If any of the lines are missing or ink has obstructed the lines it will cause the error when the carriage moves back over the service station since it will be in the wrong position when the service station cleaners move.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation