Question
Reply
 
Top Student
Posts: 6
Member Since: ‎07-21-2014
Message 1 of 4 (1,451 Views)

Error 22.1.10 in Designjet T1300ps

I have a designjet T1300 that is new during installation it displays error 22.1.10. We have changed The PCA, Ink station, service station, and connectiing board but is still displaying the error. We need your help. regards.

Reply
0
Master's Graduate
Posts: 475
Member Since: ‎08-11-2010
Message 2 of 4 (1,447 Views)

Re: Error 22.1.10 in Designjet T1300ps

I'm not sure where you are located, but all new plotters have a one year on site warranty, have you contacted HP?

Highlighted
Top Student
Posts: 6
Member Since: ‎07-21-2014
Message 3 of 4 (1,440 Views)

Re: Error 22.1.10 in Designjet T1300ps

I am located in Nigeria, the plotter was imported from US, not covered by warranty in Nigeria.
Teacher
Posts: 61
Member Since: ‎08-04-2014
Message 4 of 4 (1,392 Views)

Re: Error 22.1.10 in Designjet T1300ps

Hi Ishola,

Try these recommendations to see if they help with the error you're getting. 


Check that the cables between the Ink Supply Station and the Engine PCA are not
damaged and are properly connected. In case of any damage, replace the cable.


NOTE: Check the Data Harness and ISS Harness Cable are connected in the right
position onto the Engine PCA. These two connectors can be swapped by mistake causing
a SE 22.1:10. (The connector of the Data Harness has a blue label, and the corresponding connector on the
Engine PCA is also blue.)

 

Hope this helps,


Mike

 

_______

I work on behalf of HP

**Click the KUDOS thumbs up button to say 'Thanks'**

Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation