Post new question
Honor Student
Posts: 2
Member Since: ‎04-28-2009
Message 1 of 1 (558 Views)

ML Series Raid 1


I'm completely inexperienced using Raid 1 on HP ML110 G3.
I did follow HP's instructions on BIOS setting IDE to Raid. And then pressing F8 to configuring Raid 1.
That was 'successful'.
Upon boot these messages paint upon the screen:
HP Embedded SATA RAID controller B2067
Press F8
Loading Configuration
Port #00 149 GB Healthy
Port #01 149 GB Healthy

Array #0 Raid - 1 Raid 1 (Mirror) 148.88 GB Optimal

1 Logical Device(s) found 
Bios Found
Windows 2000 Server initiates.

Comment : Because of no usb boot support and no floppy drive I needed to create an ISO disk using
Nlight to install Windows Server 2000.

I don't know how to use Raid 1. With Admin Tools Under Disk Management I see only C: 148.88GB NTFS.
I don't see the second drive.

I download HP Storage Manager. This application reveals nothing that appears familiar.

I do know that Raid 1 Mirror is installed, configured; but, I don't know how Raid 1 is functioning, working, how to interface with Raid.
I don't know how to detect if I will have a drive failure ; and if there is a drive failure ; I'm needing advise what to do with Raid.

Is there an application I should download that would allow user interaction, interfacing?
Should I consider using Norton Ghost to duplicate, and protect the data?
Thanks for any thoughts on this topic.

Chuck M

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation