08-24-2013 11:07 PM - edited 08-25-2013 02:32 AM
compaq presario SR1215IL, Product # PL426AA#ACJ
There is no display and no beeps.
disconnected HDD and other pheripherals including RAM just motherboard (MS-6577, Ver. 4.1and power supply but no beeps.
started with single RAM chip but no beep neither display
monitor works fine
fans spin (both)
could start the cpu from front panel button
could close the cpu from front panel button 5 seconds pressing.
would be highly oblidged if could get some help
08-30-2013 03:07 PM - last edited on 02-23-2017 10:18 PM by OscarFuentes
I'm sorry you're running into this display issue. You could try clearing the CMOS.
Also did you try both RAM sticks individually in all slots?
08-30-2013 09:25 PM
09-03-2013 05:08 PM
I assume you've tried different VGA cables already.
Also, the computer stays on even though it doesn't display anything, correct? It doesn't turn on for a few seconds and then power off, right?
You've troubleshot quite thoroughly. At this point, it's going to be the motherboard, either the VGA slot or video chip on the board, unfortunately.