09-13-2010 12:31 PM
Hit the power button and get 5 loud beeps and red light flashing. Removed all 4 DIMM modules and tried to restart and still get 5 beeps (normally a memory issue) - not sure what my next step should be? Any help???
09-13-2010 12:45 PM
Hello vudu211812, Below are some beep codes for the AMI BIOS. These may apply to your motherboard and may not.
AMI BIOS Beep Codes
Code Description 1 Short Beep System OK
2 Short Beeps Parity error in the first 64 KB of memory
3 Short Beeps Memory failure in the first 64 KB
4 Short Beeps Memory failure in the first 64 KB Operational of memory
or Timer 1 on the motherboard is not functioning
5 Short Beeps The CPU on the motherboard generated an error
6 Short Beeps The keyboard controller may be bad. The BIOS cannot switch to protected mode
7 Short Beeps The CPU generated an exception interrupt
8 Short Beeps The system video adapter is either missing, or its memory is faulty
9 Short Beeps The ROM checksum value does not match the value encoded in the BIOS
10 Short Beeps The shutdown register for CMOS RAM failed
11 Short Beeps The external cache is faulty
1 Long, 3 Short Beeps Memory Problems
1 Long, 8 Short Beeps Video Card Problems
If the 5 beep code is actually related to the CPU, it may not be a faulty CPU, but perhaps a heat issue.
If it is out of warranty, and you want to attemp a repair, you can check for a dirty CPU fan, and clean the dust from the fan/CPU, or even remove the Fan only and reapply some thermal paste and then reinstall the cleaned fan and see if this resolves the issue. Make sure you reinsert the memory modules.
You can Google to see how to reapply the thermal paste.
Hope this helps.
Please click the White Kudos star on the left, to say thanks.
Please mark Accept As Solution if it solves your problem.
09-13-2010 12:46 PM - edited 09-13-2010 12:49 PM
5 beeps is a pre-video error, either bad memory or a bad motherboard.
See this document, in the "Post Error Messages:" section
09-13-2010 01:00 PM
I have 4 DIMM's which I removed & reseated and even tried to reboot with no DIMM inserted & still get the same 5 beeps. Can this be something other than a memory issue since I doubt all my DIMMs are bad.
04-22-2015 09:18 AM
I found this post when I got the same error. Turned out it was memory, someone failed to seat any memory. I suggest you test the RAM modules one at a time, one or more may be defective.
12-04-2015 02:32 PM
If you are using 2 sticks of DDR3 ram, make sure they are both mounted in the black slots, not the white ones. Slot 0 is the black slot closest to the CPU and must be filled if you are using one stick. Check the label on the inside cover of the case to confirm you are filling in the correct order.
- Downloading or Updating Software and Drivers for HP Computers
- HP PCs - Sleep and Hibernate Issues (Windows 10, 8)
- HP PCs - Error Messages Display on a Black Screen during Startup or Boot (Windows 10, 8, 7)
- HP PCs - Error Messages Display on a Blue Screen during Startup or Boot (Windows 10, 8, 7)
- HP All-in-One PCs - Troubleshooting Touch Screen Issues (Windows 8)