10-09-2012 01:55 PM - edited 10-09-2012 02:32 PM
My HP-DC7100 won't start up and it when I turn it on it flashes the red light 5 times, I looked it up and it apparently meant that it was a memory error, now I thought that was kind of weird because the RAM's were working just fine before this incident. Although this was straight after I done something, the case wasn't on properly and I pushed it into place and then the screen went fuzzy and it automatically turned off. Then I tried to start it up and now it flashes red 5 times, and I haven't even installed any additional rams, these are the RAM's that came with it. Please help!
Solved! View Solution.
Re: My HP DC7100 won't start, flashing red light 5 times?
10-09-2012 05:53 PM
Yes, I'm afraid so.
10-09-2012 04:02 PM - edited 10-09-2012 04:05 PM
Remove and reseat all of your memory modules.
If it still flashes, remove all but one and test one at a time and keep adding memory, until it goes haywire again.
Then you found the bad memory chip.
Make sure you unplug the PC each time you mess with the memory chips.
I also suggest you make sure your new video card was properly secured and everything else is in place.
10-09-2012 05:01 PM
Try clearing the CMOS and see if that helps.
See pages B-3 and B-4.
It is possible you wrecked the PC by whatever you did here..."Although this was straight after I done something, the case wasn't on properly, and I pushed it into place and then the screen went fuzzy and it automatically turned off."
That ain't good...
- Downloading or Updating Software and Drivers for HP Computers
- HP PCs - Sleep and Hibernate Issues (Windows 10, 8)
- HP PCs - Error Messages Display on a Black Screen during Startup or Boot (Windows 10, 8, 7)
- HP PCs - Error Messages Display on a Blue Screen during Startup or Boot (Windows 10, 8, 7)
- HP All-in-One PCs - Troubleshooting Touch Screen Issues (Windows 8)