07-05-2012 11:01 AM
I recently found my old HP Pavilion a6228x after 2 months of not using it, and hooked it up to my w1907 monitor with a vga cable. It says that there is no VGA or DVI input signal, with the black arrow pointing at DVI. I can't switch from DVI to VGA because everytime I press the menu button, the screen will say "Monitor going to sleep." The monitor works fine with my laptop and the same vga cable. Help?
07-10-2012 09:39 AM
>It says that there is no VGA or DVI input signal
It seems like it's scanning the vga port too, so maybe your graphics chip is no longer working?
Do you have a graphics card added?
Have you tried to boot into safe mode or do you have no display at all?
07-23-2012 11:07 AM - edited 07-23-2012 11:10 AM
Since the monitor and cable are known to be good then make sure that you are plugging the video card into the video card's VGA port if a a video card is installed. If the video card has a DVI port then use a native DVI cable between the monitor and the video card.
If there is a video card in your PC then try reseating it (remove and replace). If that doesn't work then remove the video card and plug the VGA cable into the motherboard's VGA port.
Only connect one active video feed to the monitor.
Try a monitor reset. Unplug the monitor’s power cord and hold down the monitor’s power button for 30-60 seconds. Plug the monitor back in and power it up.
HP ENVY 17T-u100, i7-7500U, NVIDIA 940MX, 16GB, 512GB m.2 SSD
HP Photosmart 6520, HP Deskjet 1112
HP Touchpad, HP Chromebook 11
Custom i7-4790k, Z97, 16GB 2400 MHz DDR3, Intel 750 PCI-E SSD, (2)Samsung EVO 840 SSD, Corsair HX650, GTX 980TI, Corsair H75 water cooler
Windows 10 Pro in UEFI mode - production system
Windows 7 and 8 in UEFI mode - test systems
03-13-2013 03:21 AM
If yes, then your graphics output has gone.
If no, then you can check memory, hard drive - else your mobo has gone.
- Downloading or Updating Software and Drivers for HP Computers
- HP PCs - Sleep and Hibernate Issues (Windows 10, 8)
- HP PCs - Error Messages Display on a Black Screen during Startup or Boot (Windows 10, 8, 7)
- HP PCs - Error Messages Display on a Blue Screen during Startup or Boot (Windows 10, 8, 7)
- HP All-in-One PCs - Troubleshooting Touch Screen Issues (Windows 8)