05-13-2009 03:56 PM
Was wondering if anyone could help me out............
I have checked Bios and my System Fan runs about 700-800rpm when tower in Horizontal position and no errors occur. When I stand my tower in the vertical position my system fan immediately starts to drop speed until as low as 360 rpm then it jumps to 0 (fan still turning though) and you can see a little flicker in the background trying to read around 360ish rpm. When I exit Bios at this moment I then get error below:-
System Fan Error immediately service unit or press f2 to continue - I normally have my tower in the vertical position
Model: Compaq SR2129UK
05-18-2009 10:44 AM
1) Open up the tower while off and disconnected and check the processor fan and the case (exhaust) fan and make sure they spin using your finger and that no cables are tocuhing them.
2) If they're fine, then try following the 3pin cable from the fans to the motherboard and take it out and out it back. Do this for all other fans.
3) Put everything back and turn on the pc and if you get this message press F2 to ignore it.
Important Note: You mentioned that you monitored the fan speed. Normally on HP systems BIOSes it doesn't show that unless you installed everything in your own case (tower) like I did. This happened to me when I switched just the tower but kept all the components.
In this case it isn't a problem just a little annoyance until you get another motherboard.
I believe this also happens when you switch cases because some of the front panel and usb connectors are left in the Hp case (old) and those aren't connected to it like before. But again if all fans work and connected there's no problem.
- Downloading or Updating Software and Drivers for HP Computers
- HP PCs - Sleep and Hibernate Issues (Windows 10, 8)
- HP PCs - Error Messages Display on a Black Screen during Startup or Boot (Windows 10, 8, 7)
- HP PCs - Error Messages Display on a Blue Screen during Startup or Boot (Windows 10, 8, 7)
- HP All-in-One PCs - Troubleshooting Touch Screen Issues (Windows 8)