Question
Reply
 
Tutor
Posts: 8
Member Since: ‎06-27-2011
Message 1 of 4 (590 Views)

w2207 Monitor

I have the monitor connected via a USB 2.0 VGA adapter to an HP EliteBook 8460p and via a DVI cable to a DIsplay Port Adapter on a MacBook Air (MBA). If the EliteBook is on, I can easily switch back and forth and all is good. If I turn the EliteBook off, the MBA attempts to connect, but the monitor goes to sleep. If I hit the menu button, the power light turns blue and about one out of five times the MBA will connect. I suspect there is some sort of a sensing relay in the monitor that is not detecting the input properly. I'm afraid the constant attempts by the MBA to connect may cause a problem with the MBA.

 

Every once in a while, when the EliteBook is connected, when I switch to the MBA it says the display resolution is not supported. However, if I try it again it will connect.

 

Is this a hardware failure or is there something anyone can think of that might help.

Reply
0
Associate Professor
Posts: 1,635
Member Since: ‎05-17-2011
Message 2 of 4 (570 Views)

Re: w2207 Monitor

Check the solution in this case:
http://h30434.www3.hp.com/t5/Desktop-Audio-Video-Monitors/How-to-have-zr2740w-running-at-higher-reso...


HTH
V.

*** Say 'Thanks' with Kudos ***
Tutor
Posts: 13
Member Since: ‎09-02-2009
Message 3 of 4 (461 Views)

Re: w2207 Monitor (on MacBook Air)

I have a similar issue with my 2012 MacBook Air and the W2207 monitor. When I connect the monitor to the Air, often it will not properly recognize and the monitor will go to sleep instead of going into extended desktop mode instead. I have tried both the Apple mini displayport -> DVI as well as a generic mini displayport -> DVI adapter and it's the same behavior on both.  I suspect that this has something to do with the way the W2207 is built (connecting a DVI monitor via mini displayport was not popular when this monitor was released). 

 

There is, however, a workaround for me that works 100% of the time if I do things in the right order:

 

1. Turn on/wake up MacBook Air while the monitor is not plugged in.

2. Turn on the W2207.

3. Within about 5 seconds of turning on the W2207, plug it into the MacBook Air. It will recognize properly if you plug it in before it turns itself to sleep.

 

This is a pain to do, and it also means I have to unplug and replug the monitor into my Air every time I wake up the computer, but at least it's consistent.

Highlighted
Tutor
Posts: 13
Member Since: ‎09-02-2009
Message 4 of 4 (416 Views)

Re: w2207 Monitor

The solution in the post you link to is referring to a monitor which has displayport.  W2207 is DVI and VGA only. Definitely do not want to go down to VGA quality.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation