- HP Support Forum Home
- >
- Your Voice
- >
- Forum Feedback
- >
- Re: Thread exceeding borders
HP Support Forums
Join in the conversation.
- Subscribe
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Thread exceeding borders
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
11-21-2008 01:35 PM
Might anyone pls check this thread:
http://h30434.www3.hp.com/psg/board/message?board.
The width is by far to big and it can note even fully be shown under 1280*1024 resolution.
Rainald
Re: Thread exceeding borders
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
11-21-2008 02:12 PM
Rainald
Thanks for your post! We are aware of this issue and are working on it. I posted a note in the tips and tricks section that this may occur
at the following thread
http://h30434.www3.hp.com/psg/board/message?board.
Welcome again to the Forum!
regards,
HP Forum Admin
--Say "Thanks" by clicking the Kudos Star in the post that helped you.
--Please mark the post that solves your problem as "Accepted Solution"
Re: Thread exceeding borders
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
11-21-2008 04:32 PM
Thanks for the reply, Dani.
It seems that is an issue which in some odd cases happened with the old forum technology too.
I'd suggest that you might a recommendation to use a "tinyURL" in case someone wants to insert a very long URL.
Using tinyURLs in the past has been discussed controversial.
The big disadvantage is that one does not see the real reference.
Therefore the common opinion was reached that one should avoid using tinyURLs.
But in the case of a problem as given at present it should be not only allowed but recommended.
Rainald
Re: Thread exceeding borders
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Report Inappropriate Content
11-21-2008 04:55 PM
