02-03-2011 04:34 AM - edited 02-03-2011 01:22 PM
Hi, I have a HP Photosmart Prem-Web C309n-s printer. I bought it 12/26/2009 so it is just out of warranty naturally When I turn it on, I am getting an error message of ink system failure and then it says printhead problem. I have run all of the trouble shooting suggestions but the problem is still there. The ink cartridges are fairly new and full. I haven't used the printer that often in the year since I purchased it so it shouldn't be worn out??? (I've gone through the sample cartridges that came with it, and just recently installed my second set of purchased cartridges/official HP 564). So at this point I don't know what to do next. Do I need to take the printer in somewhere, or do I need to purchase a new printhead? If so, who do I contact about purchasing one and how expensive are they? I haven't uninstalled the software and reinstalled, should I try that first? Any help or suggestions would be greatly appreciated. Thanks! Peiable
02-03-2011 01:16 PM
Yes, I've done all of the troubleshooting suggestions from HP. I've unplugged and restarted, taken the print head cartridge out and cleaned it per their instructions, restarted my computer, anything they suggested, I tried. But the problem is still there.
06-08-2011 06:10 PM
I have the exact same issue. I recent replaced my cartridges and now I am getting the following message:
REMOVE ALL CARTRIDGES. NEXT, LIFT BLACK LATCH AND REMOVE PRINTHEAD. THEN RE-INSTALL PRINTHEAD AND CARTRIDGES.
I have performed all troubleshooting steps I can find on this issue. PLEASE ADVISE US ALL on what course of action we need to take to fix this - HP.
If we need to purchase a new Printhead, please give us links or locations to do so. Thanks !!
08-16-2011 01:19 PM
I have had exactly the same problem. I haven't had a printer/scanner for about 2 months now becuase I can't find anyone who knows how to fix it.
It seems that nobody on these forums does too.
11-14-2011 11:56 AM
I did all the what they wanted me to do pulling out the cartridges and re-install printhead and cartridges and still same. I cleaned printhead a instructed still printhead problem. I turn off for 10 minutes pulled out plugges and reinstalled them and still ended up print head problems. What next buy a new print head ? There is no bipass? I"ve changed printer with new ink several times with no problem because it sucks up ink so fast. What happens to the printheads? How much do they cost and if I purchase another will it work?
01-22-2012 12:21 PM
I am having error OXC19a0041 like everyone else it seems
It is as simple as purchasing a new printhead to resolve the issue?
I have already changed all the iink cartridges
Where did you purchase the inkhead from?
01-23-2012 03:00 PM - last edited on 04-18-2016 04:11 PM by OscarFuentes
Just in case, this document generally resolves the issue, short of hardware failure in which case the service the product section would apply:
I was a support engineer for HP.
If the advice resolved the situation, please mark it as a solution. Thank you.