10-13-2009 01:18 PM
Hi! As dumb as this sounds I'm having a major issue changing my print head. The real issue is on the HP service page for the K550 they show an illustration showing 2 latches for lack of a better term that you pull up first, to get to the old print head. Well on mine there is nothing like that. And nothing else is familiar about the illustration on the inside, however the outside is still the same model, with the 4 ink cartridges going in on the left. I have searched and found nothing about this. There doesn't seem to be any latches or any way to even get to the printheads even after taking the ink cartridges out.
Any help or ideas much appreciated!
10-13-2009 04:40 PM
First of all, is there something wrong with the printheads? I would think they would be okay, and you only need to replace the ink supplies.
That said, tell me what you do see. If you lift the top cover, using the little thumb hole on the left side, you can see where the printing happens, and there should be something at the left that looks like a latch with a picture on it. What do you see on the left side?
10-13-2009 08:39 PM
10-14-2009 08:46 AM
Hi & thanks!
That is the exact document I am talking about, however mine is totally different. There is no latch as seen in figure 2. As close as I can describe it it looks like I'm looking at the right side of the pic on that image. I've examined the front inside and above where the inkjet cartridges are inserted and there are no latches to undo or pullup even after removing the inkjet cartridges. At the front of the printer looking down you can see the 4 silver clamps, surrounded by its casing....which is attached to the back end which I assume house the printheads. The top of this piece has a flimsy plastic piece covering the 3 sets of wires going in. Could this have been an early model? I also just noticed that on the left side of the front piece where the 4 clamps are, there is a screw going into the back piece. This cannot be accessed unless the side of the printer is taken off.
And I did get the model number from the back of the machine so I'm sure its the right one.
10-14-2009 09:04 AM
10-14-2009 11:15 AM
You got it! Had I read rather then scan the instructions I would have caught that. Once I did that the rest was rather easy. You have solved my problem!
I have cleaned the printheads twice and ran tests and the cyan is still not good although it has improved approx 20%. The lights are not flashing either (which I read) to replace printheads. I guess I'll just keep cleaning and aligning etc and see what happens, but thanks so much for your help! :-)
10-14-2009 11:35 AM
- Using HP Diagnostic Tools for HP Printers in Windows
- Printer Problems after Upgrading to Windows 10
- Print Jobs Stuck in Print Queue (Windows)
- Resolving 'Problem with Printhead,' 'Printer Failure,' 'Ink System Failure,' or a '0x...' or a 'C2...' Error
- 'Offline' Printer Status Message Displays (Windows 10)