04-01-2014 12:27 PM
ready- prints-5sheets-49.4co6 error on display. unp/plug unir in-ready-prints-same code again---again---again
any suggestions appreciated
P.S. This thread has been moevd from HP Service Manager / Service Center Support and News Forum to Laserjets. - HP Forum Moderator
05-01-2014 08:17 AM
Hello, I would first try disconnecting from the network and powercycling to see if it comes to ready, then I would run internal test prints to see if the error returns. If it does not, then I would try a firmware update to the machine. If the error continues, I would check the que and delete the first job that is being sent, before deleting take note of the print job (word doc, pdf, website) and user. This way you can determine where the problem file came from.
Hope this helps....
05-01-2014 08:58 AM
49 error are most considered to be non-hardware issues, so updating firmware to the latest is always a good place to start. Also disconnect the printer from any network etc, so its standalone and try printing the printers internal pages to see if the error still appears. If the 49 error only happens when connected to the network etc, then it's highly likely nothing to do with the printer hardware itself.. In which case you would need to start trying different drivers or trying to find out which print job is casuing the failure.
- Using HP Diagnostic Tools for HP Printers in Windows
- Printer Problems after Upgrading to Windows 10
- Print Jobs Stuck in Print Queue (Windows)
- Resolving 'Problem with Printhead,' 'Printer Failure,' 'Ink System Failure,' or a '0x...' or a 'C2...' Error
- 'Offline' Printer Status Message Displays (Windows 10)