-
×InformationWindows update impacting certain printer icons and names. Microsoft is working on a solution.
Click here to learn moreInformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center.
-
×InformationWindows update impacting certain printer icons and names. Microsoft is working on a solution.
Click here to learn moreInformationNeed Windows 11 help?Check documents on compatibility, FAQs, upgrade information and available fixes.
Windows 11 Support Center.
- HP Community
- Archived Topics
- Printers Archive
- Re: LaserJet 100 color MFP M175nw no duplex printing in Wind...
Create an account on the HP Community to personalize your profile and ask a question
08-31-2015 08:03 AM - edited 09-01-2015 02:59 PM
Problem: duplex printing does not stop halfways (after printing one side) in order to enable me to flip over the paper, reload in the magazine, and press ": start" again to print the other side.
Printing goes now all the way, first the even pages (that is correct) and then immediately after that, without pause, the odd pages, upside down (that is correct too). The only problem is that there is no pause between odd and even page-printing to enabvle me to bring the stack of paper back to the papertray.
This is only in Windows 10, on another machine still working on Windows 7 duplex printing goes perfectly.
Any help would be greatly appreciated ...
Solved! Go to Solution.
Accepted Solutions
09-01-2015 11:10 AM - edited 09-01-2015 03:00 PM
I found the solution !
This is for the LaserJet 100 color MFP 175nw on a clean Windows10 installation. I do not know whether this also works for other printers.
1. Go to Control Panel / Devices and Printers
2. right-click the HP laserjet icon, select Properties, go to tab Device Settings.
3. Under installable options: Manual Duplexing, Job Separator and Status Notification:
all should be ENABLED
This is what was wrong, Job Separator was disabled after the intial install and that setting caused the printer not to pause when duplexing.
Problem solved!
09-01-2015 11:10 AM - edited 09-01-2015 03:00 PM
I found the solution !
This is for the LaserJet 100 color MFP 175nw on a clean Windows10 installation. I do not know whether this also works for other printers.
1. Go to Control Panel / Devices and Printers
2. right-click the HP laserjet icon, select Properties, go to tab Device Settings.
3. Under installable options: Manual Duplexing, Job Separator and Status Notification:
all should be ENABLED
This is what was wrong, Job Separator was disabled after the intial install and that setting caused the printer not to pause when duplexing.
Problem solved!
Didn't find what you were looking for? Ask the community