01-29-2011 11:01 PM
My Photosmart C6150 has died or is at least having a stroke of some kind.
When I started my printer it powers up the LCD normally and then the printer will make an electronic *pop* noise and shut down. It will then restart itself BUT the green ON button does not light up when it does this. The printer will just cycle on and off, on and off until it is unplugged. When it is plugged most of the time the LCD screen powers up again with no light in the ON button and it will just continue to cycle off and on.
I found another post with a problem like mine and it said to unplug the power cable from the transformer and not the wall. Plug it back in and once you turn the printer on hold the # and 6 key to reset the printer. When I do this I get various start up routines ranging from the printer shutting itself down completely to it cycling normally only to reach the first 'ding-dong' noise of a normal start up and then *pop* back to the power cycling on and off. The green light flashing on and off in the ON button.
More research shows a problem like this has been caused by faulty logic boards:
“Apparently some defective components were used in the construction of the logic board (see photo). On my C6180 there were 3 failed capacitors (the green cylinders - the puffed top indicates failure) and a 4th from the same manufacturer (TEAPO - many unfavorable web references to this manufacturer).”
This printer has never been used a lot by any means and in most cases just for scanning purposes.
Is there some other fix for this or do I have to pay someone $100 to look at my printer.
02-27-2011 02:11 PM - edited 02-27-2011 02:13 PM
I am having the same problem with mine. I am ready to throw the printer in a dumpster, it's almost never been used. I could not find any solutions myself online or with HP. What happened with your search/repair?
03-31-2011 08:31 PM
I'm having the same issues! Tried # and 6, and # and 3, and # and 9, and OK and * and #, and black and color, and OK and Cancel. ALL these caused my printer to stop making the burp noise, but it still cycles while powering up and never fully going on,... and no green light for the ON button... except when the green light BLINKS on the ON button and ACTS like it's going to fully boot up.
Anyone have a fix, other than taking the printer apart, looking to see if the capacitor is bad? Need to find a small enough screwdriver.
04-11-2011 07:28 PM
Mt printer is now a very effective doorstop.
$200 to fix 4 pieces that cost less then $1.00 total. Not even a peep from HP going "whoops. Our mistake."
04-29-2011 02:05 PM
Same problem here. The partial reset of #3 worked a couple of months ago, but now nothing.....
Too bad for me, that I had just bought $$ worth of new ink before it went on the fritz. Anyone know if they have newer printers that use the 02 ink?
- HP Printers - Using HP Diagnostic Tools for HP Printers in Windows
- HP Printers - After Windows 10 Upgrade, Printer Does Not Print
- HP Printers - Using Google Cloud Print with Your HP Printer
- HP Printers - Printer is Offline (Windows)
- HP LaserJet Pro Printers and Multifunction Printers - HP Smart Install Discontinuation