06-11-2013 07:10 PM
Recently I purchased a 4GB module of DDR3 1600 PC3 12800 for my laptop. I recieved it today and proceded to install it following the direcitons given in my laptop's user manuel. But the memory never snapped into place. It seems like the retention clips are not long enough or there is something blocking the module from going into the memory slot fully. I found this odd. After finding that the memory did not fit into the slot, I removed the factory HP memory module from it's slot and attempted to put it into the spare/defective slot. It also did not fit. Just for clarification, I tested the purchased memory in the workign slot and the memory works perfectly. I am wondering what might be the issue with my memory slot.
I called HP support and they said it would cost me $290 for the slot to be repaired. I find that way to much considering I only paid $300 for the laptop itself.
Any help is apprechiated.
Solved! View Solution.
Re: g7-2235dx - Memory Slot Defective/Memory Does Not Fit In Slot
06-13-2013 07:03 PM
06-12-2013 11:55 AM - edited 06-12-2013 11:56 AM
This is two stacked memory slots, right? Look inside the offending slot and see if maybe there is a chunk of dirt in there. It would not take much to block the memory module from seating fully. If you see something in there blow it out with compressed air.
This is the picture of the memory slot from the Service Manual. It does not do a good job of showing that there are 2 stacked slots. They are slightly offset so the top module is a bit below the bottom module when both are in place. Was the original single module in the top or bottom slot; likely the bottom?
06-12-2013 12:19 PM
06-13-2013 03:26 PM
Then it is a one in a million manufacturing defect in the memory slot component. The only fix is going to be a new motherboard, I am afraid.
06-13-2013 03:57 PM - edited 06-13-2013 03:57 PM
So what are my repair options? I don't want to end up paying the equivalent of a new laptop in bills.
06-13-2013 07:03 PM
07-22-2013 07:41 PM
The slot is defective and I didn't want to pay the fees for a new motherboard. I have sold that laptop and purchased a new HP ENVY 15z-j000, so far so good.
- HP Notebook PCs - Reducing Heat Inside the PC to Prevent Overheating
- Computer Does Not Start and the LEDs Blink or the Computer Beeps
- Performing a Hard Reset or Forced Reset
- HP PCs - Improving Slow System Performance and Maintaining Your Computer (Windows 10)
- HP PCs – Resolving Slow System Performance (Windows 8)