Desktop hp s3100n - No beep, blank screen (1423 Views)
Reply
Student
johnny009
Posts: 1
Registered: ‎03-16-2009
Message 1 of 2 (1,423 Views)

Desktop hp s3100n - No beep, blank screen

I have a hp s3100n desktop recently have no display on monitor.

I replaced new motherboard and memory but didn't solve the problem.

It powers on but no beeping sound and blank screen.  I also have tried

reset SMOS baterry and jumper. 

Anyone have any idea?  

 

Thanks for response

Teacher
dago517
Posts: 133
Registered: ‎02-19-2009
Message 2 of 2 (1,406 Views)

Re: Desktop hp s3100n - No beep, blank screen

Was it this way before you replaced the parts?

 

All these concern the monitor. Do not skip these suggestions. Do them again.

 

Is it on?

Check all cable connections? Disconnect them and then reconnect them.

Have the monitor settings been changed? Try and adjust them. You might set them all to the half way position to begin

 

I'd suggest (others may disagree) at this point take it to a shop. Adding those new parts has compounded the possible problems to the point the problem may no be repairable from here. Just too many variables to consider. This problem may require a "hand on" fix.  This might also be the cheapest way to get to a solution. A new graphics card and monitor are still in play as possible solutions.

 

 

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation