HP Support Forums
Join in the conversation.
12-30-2009 01:53 AM
I installed Windows 7 on my laptop (on Hp HDX X16T-1200 CTO \ p/n NK133AV) and have gone to the HP site and downloaded the Fingerprint scanner driver and the Digital Persona Software. My laptop, however, is not recognizing that the fingerprint scanner exists, even with the driver installed. Help?
12-30-2009 05:44 AM
Please ensure you install both Validity Fingerprint Sensor Driver and Digital Persona Fingerprint Reader Software.
To my knowledge Both are needed to make the finger print sensor to work.
Make it easier for other people to find solutions, by marking my answer “Accept as Solution” if it solves your problem.
***Click on “Kudos” STAR to say thanks!***
04-05-2011 08:30 PM
I had the exact same problem and I realized thx to this response that the answer lies in getting both the validity Fingerprint Sensor Driver and Digital Persona Fingerprint Reader Software which can be found following these links : validity sensor driver and Digital Persona Fingerprint Reader Software . I had already downloaded the Digital Persona Fingerprint Reader Software so I just had to get the validity Fingerprint Sensor Driver which took only a few minutes and I was set to go. You might wanna make sure you have the latest version though. Hope this helps.
12-26-2011 03:42 PM
I get "Sensor not connected. Please connect sensor and try again." when I try to go into Simple Pass 2011 on my new laptop. I checked the drivers made sure the Biometric Device in Device Manager is enabled. I reloaded the drivers for the device and I disabled and then enabled it again. When I restarted my laptop it worked until fine until my laptop went into hibernate mode. Please advise me on this.
02-09-2012 07:21 PM
I have DV6 pavilion laptop just few months old and the fingureprint scanner had been patchy right out of the box.. It would work on and off and now it has quit working.I have the latest drivers for validity and latest version of Simplepass and just did the latest bios update.
The HP response is to reset to factory condition, which is useless. How long one can work without adding any programs or files?
Any one has any idea what to do.
03-10-2012 08:44 AM
Saw this on another forum because I have had a similar problem with my laptop (mostly after waking it up from sleep mode). seemed to work for him.
"A while back I had a similar problem on my laptop.
What I did was disable power saving mode in the fingerprint reader driver.. This should work for you also.
Go to the Device Manager and choose the fingerprint reader under biometric devices
Right click and go into the driver properties and disable "Allow the computer to turn off this device to save power" under Power Management."