Question
Reply
 
Student
murphyrl
Posts: 1
Member Since: ‎05-30-2013
Message 1 of 2 (166 Views)

8770W and two monitors

I have a 8770W and a HP dockin station.

 

The docking station as a DVI and VGA video port.

                    I have a 2311XI - connected to the DVI

                    I have a 2311X - connected to the VGA

 

I have the laptop docked and screen down - When I go to see resolution screen i see two montiors

       The Active one is a HP 2311XI (Monitor 1) and next too it is Montior 2 (HP2311X)

             When I go to extend the display to both monitors it does and then PC Beeps and both screens blink

             It contunes to do this until i go back to Display 1 only

When I try to do make Display 2 the only display it does and then starts to blink as well until I go back to display 1 only.

 

Per HP I have flashed the Bios and reinstalled the video

            They even had be go in and untinstall the video manually

                   Whem I did this and then ran SP60893 it would install the video driver.

I ended up doing a recovery and now back to square one.

 

Anyone have any idea's 

 

Distinguished Professor
Kyle_W
Posts: 4,755
Member Since: ‎04-26-2011
Message 2 of 2 (144 Views)

Re: 8770W and two monitors

Your notebook is a Enterprise/Business/Commercial model.  As these are the consumer forums, I would recommend that you post this in the HP Enterprise Support Forums for better coverage.
 
You can access the enterprise support forums at the following link.
 
 
Best of luck,
Kyle
 
-------------How do I give Kudos? | How do I mark a post as Solved? --------------------------------------------------------
Signature
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation