Honor Student
Posts: 2
Member Since: ‎08-07-2013
Message 1 of 2 (193 Views)

Boot up problem

I split diet coke on my laptop and i immediately turned it off, tipped it upside down and then soaked up the liquid. I have left the computer 24hrs.

Now when I turn it on it starts to boot up. But then a message comes up which I haven't seen before.


Yukon PXE v6.50.2.3 (20071025)

(C) Copyright 2003-2007 Marvell (R). All rights reserved

Pre-boot eXecution Enviroment (PXE) v2.1

(C) Copyright 1997-2000 Intel Corporation.


After this is on the screen for a while it then comes up with the below underneath.


PXE-E62 : Media test failure, check cable

PXE-N0F : Exiting PXE ROM


Once that is done it comes up....


Non-System disk or disk error

replace and strike any key when ready


And that is where it stays. Help?!?!?


Honor Student
Posts: 2
Member Since: ‎08-07-2013
Message 2 of 2 (192 Views)

Re: Boot up problem

Sorry....forgot to say I have an HP 675s (old i know) and use wndows vista

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation