08-21-2010 04:19 PM
HP G60-441US one month out of warranty. Trying to fix it for my dad.
Boots and runs normally (considering the amount of bloatware installed) on external monitor.
Usually will run for 20 or 30 seconds before the backlight switches off. (still can see faint image, external monitor normal)
Repeatedly opening and closing the lid switch will sometimes bring it back on. Or just waiting 5 minutes doing nothing will sometimes bring it back on. If you do have a normal display, closing and opening the lid will almost always make it go away. Thought this was a simply a bad inverter.
HOWEVER. The thing runs just fine in safe mode. Booting to safe mode makes the display pretty much rock solid.
You can open and close the lid 10 times in 10 seconds, and the backlight will go on an off as reliabley as any light switch in your house.
So hardware or software? Does safe mode result in less processor and graphics chip overhead, and things are running cooler? Or is there some bug or corruption in the drivers which monitor the lid switch and sleep mode?
I'm sort of at a loss as to whether I should waste an evening trying to flash the bios (if it's even possible) and reload graphics drivers, or I'd be better off trying to clean the dirt out of the fan, (it's pretty clean though). Or I should just bite the bullet and buy a new motherboard (or computer)
Is this a known problem with this model?
12-14-2010 06:00 PM - edited 12-14-2010 06:06 PM
I also have a G60 230CA with the same problem.
Starts up, and will be extremely dim...can barely see the logon screen. Opening and closing the lid sometimes helps. Usually it will flicker then go back to being dim. HP wanted 400 dollars to have it sent in which is outrageous since it is also barely out of warranty. Most forums have directed the problem at the backlight or inverter. These are expensive repairs in Toronto. I am usually quoted between 160-220 for local repair shops to fix it. Does anyone know if HP has recognized this issue and has a solution? If it is a common problem than perhaps there is a definitive answer to it? I just don't want to spend money for a diagnostic, then have someone replace the inverter and/or backlight and not have the problem solved.
Any others with this problem who have had it solved?
12-26-2011 08:54 AM
I'm having a similar problem and through my research I've been told its my inverter also. Mine is fine on start up and what not. I have a small black spot on the bottom right hand corner of my screen. Its super hot to the touch. When I plug my laptop into the power cord, the backlight flickers and goes out after aout 3 minutes. So I can't use it for extended periods of time anymore which tends to take away the convenience of it. Any help at all would be greatly appreciated.
08-14-2013 03:22 PM - edited 08-14-2013 03:29 PM
I'm having the exact same problem, except that my screen does not flicker any longer. It just stays dim. But I can see the desktop if I hold a flash light to it. I've replaced the inverter board... no success. I've also removed the top cover (key board, etc) and played around with the wires)... no success. So my system is basically useless unless, of course, I connect it to an external monitor. Then it works fine, but I can no longer take it on personal outings, and that sucks! I've spent a lot of time searching for an answer with no success. Some say it's the inverter, but I've replaced that. Others say it's the back light, which will cost about $250 to repair. And some even say it's the video cable or lid switch... who knows. All I know is that I paid $800 for this system and I'm not getting the service I deserve. It's totally frustrating. After months of searching I finally located the HP G60 Notebook PC Maintenance and Service Guide, which I intended to use to find the laptop's lid switch so I could determine if it is the culprit, but the service guide provided no information on the lid switch's location. Now I feel like giving up. It's almost impossible to find the information needed to repair this thing. I'm done venting and seeking more advice. Where exactly is the lid actuator switch located on an HP G60-230US laptop computer? An acutal photo would really help. I will also avoid HP products from this day forward. Thanks and goooooooood lucccccck!
02-27-2015 08:23 PM
Any further updates to this?
I'm working on a friend's laptop now, and as with the OP, the backlight is *rock solid* in safe mode, which makes me think it isn't (purely) a hardware issue. When booting up normally, sometimes closing and opening the lid seems to work, sometimes it doesn't. But I can leave it in safe mode for hours or days and the backlight never goes off.
- Troubleshooting display brightness (Windows8, Windows7 and Widnows Vista)
- HP PCs - Sleep and Hibernate Issues (Windows 10, 8)
- HP PCs - Updating Drivers and Software with Windows Update (Windows 10, 8)
- HP Notebook PCs - Touch Screen Issues (Windows 8)
- HP Notebook PCs - Green Screen and Other Video Playback Issues (Windows 10)