CP1025nw - Wireless Blinking After Online Install ePrint Software

[NCPS]

Just bought the CP1025nw,USB , LAN and Wireless setup without problem on the desktop computer.

Than go to HP web-site to download and install the ePrint software,till the very end of the installation an Error message pop-up (did not see the content properly) and thought is was normal , than restart the printer and desktop computer.

After restart , the Wireless activation button on the printer kept blinking when press to turn-on the Wireless connection for the desktop computer Wireless Adaptor to detect and auto-connect, the initial SSID cannot be found for the wireless adaptor to auto-connect.

I tried the printer shut down reset (off power than press "green" botton for about 10 sec and released)...do not work.

Than in LAN connection, inside the Configuration IE web-page,done a System restore to factory setting and restart both printer and computer.

Both above done but the printer wireless button still kept blinking in blue.

Any ideas how to resolve ? I want the wireless connect back .....pls help. 

[RobertoR]

Hi NCPS hope you aare doing well and sorry to learn that you are having this issue;

This link will provide you with a lot of articles in regards your printer from how to's to trouble shooting most of the issue you may encounter with your printer 

In regards your current issue this article should provide good advise Click here 

Bear in mind This is a commercial product. I will suggest posting in the forum for HP Business Support as well for yet  a better chance at finding a prompt solution.



You may find the commercial Laserjet board here.
http://h30499.www3.hp.com/t5/Printers-LaserJet/bd-p/bsc-413

Thanks;
RobertoR

Hope it helps; 

RobertoR