HP Support Forums
Join in the conversation.
10-17-2009 11:57 PM
Recently purchased an Officejet Pro 8500. Followed setup instructions but printer cannot align printheads. Have reinstalled printheads, cleaned heads, etc. but to no avail. Self diagnostic Test indicates both printheads are good. If I click "OK" when the printer gives the alignment fail message. then I can print one document, then the printer goes through the whole printhead alignment process again ending with the same fail message. Any thoughts as to how to fix this? Thanks.
10-18-2009 12:06 AM
One other thing I wanted to add was that the printer does not print the Cyan color. The I've put in a new cartridge so there is plenty of ink. The self diagnostic indicates full ink level, yet I get no blue color. Could this have anything to do with the printhead alignment problem mentioned in my first email, or is this an entirely separate problem with this device.
06-16-2010 02:30 PM
8500 pro won't align I ran it 3x then 1x manually it says to refer to device documentation for details where do I find device documentation Joe I've been playing with this for days
10-19-2010 05:37 PM
printer will not align. prints yellow lines about 1 inch apart vertically. looking at the internet, it looks as if this is a common problem or defect. please help
12-25-2010 08:30 PM
It's hard to believe this story is true, but I assure you it is all true.
1- In October 2009 we purchased an HP Officejet Pro 8500. Not long after installing it we got constant messages "Printer is offline." Called HP and learned that it was a hardware fault and could only be resolved by sending us a new printer.
2- A new HP Officejet Pro 8500 arrived by FedEx with instructions how to remove specific parts from the old printer and send it back within a specified number of days or we'd be charged for the new printer. We set up the new printer and while setting up we get the message "Printhead error."
3- We call HP. They say the only solution is to send out another new printer.
This story goes on-and-on. We are now sitting here 14 months later with the FOURTH HP Officejet Pro 8500 sent to us by HP via FedEx and when turning the printer ON it tells 1) Cyan cartridge is low. But it's a brand new cartridge. 2) the Printhead problem is here again.
Did I mention this is the FOURTH printer that they've sent to us?
When we call HP it's like starting from scratch every time. No one has a complete, accurate record of these extraordinarily bad experience with HP. We have to walk them through step-by-step what we've been through. We must almost beg them to quit putting us through this. Tomorrow I think we'll go out and buy a new printer by Canon or Epson or just any printer that's not HP and meanwhile we'll just let HP keep sending us new printers because it seems like they have endless resources to throw away rather than to just simply solve our problem.
What has happened to what was once a great company? This is truly pathetic. How much money has HP spent sending us new printers and getting the old printers back via FedEx?
I want to find every forum possible on the Internet to make users aware of this kind of service and response from HP.
01-04-2011 11:48 AM
Had the same problem, called into tech support and when obtaining the serial number I noticed the paper tray along the back of the printer had been dislodged by my son and was why the printer would not align properly.
Easy fix.... heres to hoping you have the same issue.