c4480 incompatible ink cartridge

[Etienne]

I have the same problem with my HP Photosmart C4480.

Having read the above I have come to the conclusion that there is no solution and one should DEFINITELY AVOID BUYING HP PRINTERS.

[Kirstymi · Accepted solution]

Hy. I have found a different solution for c4480 "incopatible cartrige". it worked for me so i hope it works for you to Steps: 1. Press X power at the same time 2. Press BLUE, GREEN, GRAY 3. press BLUE until you see "INFORMATION MENU" 4. press OK 5. Press Blue until you see "CHECKSUM FOR RELOCK DATA INPUT" 6. OK 7. Press X until you exit all menius 8. When promted for aliement cancel it with X. It should bypass the error

[paula14]

This worked for me.  I have a C4480 purchased in Italy and I had bought some cartridges in the States

where they are much cheaper, but they wouldn't work.  I was ready to throw the printer out of the window.

The idiot where I bought them said they would be 'compatible - no problem'  !!

Only slight downside is that you can no longer get the proper messages about estimated ink levels.

Thanks.

[Ciara_B]

---

paula14 wrote:

This worked for me.  I have a C4480 purchased in Italy and I had bought some cartridges in the States

where they are much cheaper, but they wouldn't work.  I was ready to throw the printer out of the window.

The idiot where I bought them said they would be 'compatible - no problem'  !!

Only slight downside is that you can no longer get the proper messages about estimated ink levels.

Thanks.

---

Hi paula14, glad to hear the tip from kirstymi solved the problem for you. Are you able to get the estimated ink levels when you go through the Toolbox? See link below

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01004653&tmp_task=solveCategory&cc=us&dlc=en&lc...

Ciara

[abbiea01]

You are an absolute genius! After spending nearly an hour following advice from HP employees about taking out cartridges, cleaning them, putting them back etc and wasting two perfectly good (and ridiculously expensive) cartridges I found your message. Pressed a few buttons, took about a minute and printer is back working. Thanks so much. I'm glad someone had a sensible solution!! 

Thank you

[Ciara_B]

Hi abbiea01

Glad to hear it's back working!

Ciara

[CAZ666]

 THANK YOU YOUR POST SAVED MY PRINTER FROM BEING THROWN OUT THE WINDOW.  YOUR SOLUTION WORKED A TREAT 

[dancip]

Thank you for helping me to get closer to a resolution...  Unfortunately, I'm having problems with Step #3. - I can see that the menu choices change when I press the BLUE button but I'm not seeing a menu choice labeled "INFORMATION MENU".  WHAT I do see is the following menu choices of:  "Underware : rhLx..", "boot code menu", "copy menu", "photo menu", "scan menu", "scan udw menu", "system menu", "ui menu" - but sadly no "INFORMATION MENU".

Any additional assistance will be greatly appreciated..

Thanking you in advance,

Dan

[missmagus]

I followed the instructions but could never get "information menu" - it was not one of the choices.  Is there another way to take care of this error message.

Thanks -

CG

[MorrisY]

You have used the wrong sequence of colour buttons.  This is what you'll get if you use BLUE GREY GREEN instead of BLUE GREEN GREY.

While this is an ingenious fix, I have found that it needs to be used repetitively.

Hope this helps.