05-30-2014 03:01 PM
I received an Error 79 message and was unable to print. I tried all the simple steps suggested in the Manual and on the Forum (turning on/off, plugging directly to a wall outlet) without any change. So, I deleted the software and reinstalled the appropriate firmware & drivers. However, despite 2 attempts, the drivers did not completely install. Now, while the printer does simple printing, the "Properties" function (which enables duplex printing) doesn't work - the message reads "hpmsn101.dll has stopped working."
What can I try next? Any suggestions very welcome.
06-02-2014 01:32 PM - last edited on 03-06-2017 06:03 PM by OscarFuentes
Welcome to the HP Forums MelSB,
I see by your post that you weren't able to fully install the printer software and are now getting the error "hpmsn101.dll has stopped working". I can help you with this issue.
The printer software unfortunately will have to be uninstalled and reinstalled again.
Make sure the printer is in a ready state.
Access the Print Server Properties. How to Locate Print Server Properties for Windows 7.
On the driver tab, remove the Laserjet and universal drivers and the PCL drivers.
Then in the devices and printers window, delete the printer.
If you are using a USB connection, disconnect the cable.
Then disable all the start up programs and temporarily turn off the Antivirus Software. How to use MSCONFIG .
Click on the start up tab and click disable all.
Then run the HP Printer Install Wizard fro Windows.
Test the printer.
Then you will need to go back in and enable the start up programs and turn the Antivirus Software back on again.
If there is anything else that I can help you with just let me know.
Have a nice day!
I work on behalf of HP
Click the Thumbs Up below to say “Thanks” for helping!
02-24-2015 02:33 AM - edited 02-24-2015 03:32 AM
Please ensure that the Full features driver is install on your system . Then Go to device and printers then right click on the printer icon and select printer properties. Select device setting button and disable to printer status notification.
For the 79 Error you have perform Firmware update for the printer.
go to your country hp web page and download the firmware and please ensure full driver installed andthe printer connect via usb cable for the firmware update.
Say thanks by clicking the Kudos thumb up in the post.
If my post resolve your problem please mark it as an Accepted Solution