Post new question
Honor Student
Posts: 3
Member Since: ‎08-10-2009
Message 1 of 1 (1,872 Views)

Not Set Up on PC (vis a vis Scanning)

I replaced the Imaging Drum and now when I try to scan to the computer ie. to a folder, I receive a "Not Set Up on PC" at the 2840.  Is there anything about opening up the unit that messes up communication between the unit ant the computer?  In an attempt to fix the problem, I completely uninstalled and reinstalled all the HP software.  Although a royal pain, that reistablished the connection.


However, at the end of the day I shut everything down and this morning after booting everything up, I'm met with the same problem. Any ideas as to why this is happening, how I can avoid it and a permanent solution.  Thanks.

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation