12-12-2013 12:19 AM
I am service engineer in a complex, i am facing a peculiar problem in color laserjet 3600, when we switch on and give a color print command from system it prints black and white print. when i reseat toner cartridges, transferbelt, formatter etc it gives a couple of color prints then its back to its original path starts printing black and white. This is a problem which no one could solve till now in spite of best efforts and suggestions after cleaning developer solenoids and cleaning inside the problem is unsolved.
Can any one suggest the possible solutions for this black and white printing problem. I heard the same problem from my friends who use the same 3600 color laser, when I reset the settings it prints in few color prints and goes back to black and white. It is strange to see this happens in all the printers I have, and my friends who use the same printer also have the same trouble. Please suggest me the possible solution , I will be grateful for any suggestion or guidance to clear this problem. This is becoming a big issue in my life.
indivar reddy secunderabad
P.S. This thread has been moved from HP Service Manager / Service Center Support and News Forum to Laserjets. -HP Forum Moderator
01-16-2014 04:16 AM
If the internal test pages such as supply pages, diagnostic pages PRINTS only in black and if the color boxes are missing
Please verify the engine test page to check if all the color lines are printed ( steps-place a media in tray 2 and push the engine test switch on the rear side of the printer ), if the engine test page is also giving the same issue
It may be due to the Main drive assembly is misaligned , if you are an authorised hp technician ,you can align the MDA to check for improvement . if the engine test page is tested ok with all the coloured lines ,formatter could be the cause of the problem but it very rare that formatter can cause the above issue .Before Formatter is suspected ,Peform cold reset and check the status .
Although I am an HP employee, I am speaking for myself
Click the Kudos star if this was helpful. Thank You!
05-14-2014 01:03 PM
There is a feature on the CLJ3600 called Mono Printing When a Color Cartridge is Out. If that feature is activated, the printer will only print black and white. There are two things you can do:
1.) Print a Supplies Status Page. You can do that by going to the Reports Menu within the control panel. Select the Supplies Status Page. If you have a low or out color cartridge, that could be the problem.
2.) Perform a Cold Reset. This will reset the printer to factory defaults and should reset the mono printing when the color cartridge is out setting. Please be aware that this will also reset any network settings.
-Turn the printer power off... then turn back on.
-Hold down the check mark key on the control panel continuously until the display panel states "Cold Reset".
-At that point the printer will re-initialize and come back to a Ready state.
I am an HP employee speaking for myself and not HP.
05-14-2014 07:27 PM
- HP LaserJet Printers - 'Printer is offline' Message Displays on the Computer and the HP Printer Will Not Print
- HP Single-Function and Multifunction Printers - Find and Fix Common Printer Problems Using HP Diagnostic Tools for Windows
- Using the HP Print and Scan Doctor for Windows to Help Resolve Printer Issues
- Fixing Print Quality Problems for the HP Deskjet 2540 All-in-One Printers
- HP Printers - Print Jobs Stuck in Print Queue (Windows)