Showing results for 
Search instead for 
Did you mean: 
New member
1 0 0 0
Message 1 of 1
Flag Post

Can't Set Exposure

HP Recommended
HP 3D Scan
Microsoft Windows 7 (64-bit)

I'm trying to run calibration and set up my cameras & projector. I'm getting a lot of flickering/ visual waves in the live camera view. Everything I've read says to set the exposure to 1/60 s, however, the software seems to have locked out the option to manually enter a number. The slider runs from 1/16, 1/32, 1/64, 1/128, etc. 1/64 is the closest, but it still flickers. Projector is the standard Acer K132 at 60Hz, dual cameras are DAVID-Cam-4-M. Changing the frame rate limit doesn't make any difference. I'm running HP 3D Scan Pro 5.6.0, setup type is HP 3D Structured Light Scanner Pro S3. Any ideas?

Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation