Having trouble signing in? Try this!
Post new question
Posts: 64
Member Since: ‎11-05-2016
Message 1 of 2 (971 Views)

David 5.1 Optomize Dual Camera Still a Problem

[ Edited ]

With optimize dual camera on:


Optomize on measure 1.jpgOptomize on 3-4-2017.jpg


With optimize off:


Optomize off measured 1.jpgOptomize off.jpg


No changes at all except the software setting turning "optomizedualcamera" on and off. This was a clean Install of David 5.1 so all the settings were at the default except the calibration scale and I turned on the "Prevent Processor Idle State"function.


I should have more time today to play with it. I'll post more when I have it.

0 Kudos
Posts: 18
Member Since: ‎02-12-2017
Message 2 of 2 (885 Views)

Re: David 5.1 Optomize Dual Camera Still a Problem

Hi Micr0.

I'm using David5 too. I've found than with concave corner, If "Auto Detect Calib Conner Setup" is enable, Meshes will be distorted. But I've never experiment any distortion due to Dual Camera Optimization or due to using dual cameras.

Meanwhile by using convex corner, by enabling "Auto Detect Calib Conner Setup",  no mesh distortion was seen.


Micr0 you have lots of experiment about DavidLaser Scanner. Can you Guid me how to solve my problem on below link?

How do you manufacture CalibBoard? I think no Printer can print Calib pattern precisely. when I calibrate my setup, Cubics corners are not exactly at the center of circle.






† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation