Having trouble signing in? Try this!
Post new question
Posts: 64
Member Since: ‎11-05-2016
Message 1 of 1 (751 Views)

David 5.1 OptomizeDualCamera Still Not Good.

Operating System: Microsoft Windows XP

I installed David 5.1 and tried a number of experiments to gauge any improvement to the Calibration routine. I was really hoping that the optimize dual camera function was fixed. However after a number of setups and experiments with the various settings under the advanced -> calibration tab it seems that that function is still producing the same distorted calibration. I first started by leaving every setting at default and calibrating to a 200mm calibration corner I use often. I then Scanned the corner and observed/measured the results. With the Optimize Dual Camera setting off I the scans were measuring 90.0046 degrees panel angle. Optomize off measured 1.jpg



With the setting on I measured 90.7368 degrees:


Optomize on measure 1.jpg


The calibration information is different between the two as well.


optimize off:


Optomize off.jpg


Optimize on:


Optomize on 3-4-2017.jpg


Needless to say there was no physical change at all to the hardware between these two tests. I didn't touch the cameras or projector, and I changed nothing in David except turning on and off the Optimize dual camera function.


Hopes this helps.




In looking over my notes the differences between on and off are less then they were in version 5.0.7 but that was a different setup up so I cant say there weren't other factors involved.

0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation