Having trouble signing in? Try this!
Post new question
Question
Reply
 
Honor Student
Posts: 3
Member Since: ‎01-15-2018
Message 1 of 6 (704 Views)

Fusion-Problems with David SLS3 (HP 3D-)Scanner

[ Edited ]
Product Name: David SLS3 HD Scanner
Operating System: Microsoft Windows 10 (64-bit)

Hi,

 

all will work fine, but i can not Fusion it right. There are many troubles, but i hope, it is only a little problem...

I had bought an David 3D SLS-3 Scanner-Set. 

I had scanned a bad part, which I want to replace right with my 3D Printer.

If someone had an Idea or can help, it will be a great help! Is there a German Video Tutorial?

This will help very well, because my english is not so good... Smiley Wink

I had the file in my Dropbox

 

thanks for helping everyone!

 

Digibike

Reply
0 Kudos
Honor Student
Posts: 3
Member Since: ‎01-15-2018
Message 2 of 6 (592 Views)

Re: Fusion-Problems with David SLS3 (HP 3D-)Scanner

Has no one any idea, how I can make the Scan succesful?Man Sad

Honor Student
Posts: 4
Member Since: ‎11-01-2016
Message 3 of 6 (567 Views)

Re: Fusion-Problems with David SLS3 (HP 3D-)Scanner

[ Edited ]

Hello,
I think the content on the link gives you the necessary information.
However, it may be necessary to use a coating spray to obtain good quality scanning, depending on the surface condition of the part.
[edit]


Best regards.

 

Ali Osman GÜLER

Grad Student
Posts: 301
Member Since: ‎10-31-2016
Message 4 of 6 (550 Views)

Re: Fusion-Problems with David SLS3 (HP 3D-)Scanner

Your fusion result looks puffed up because of the close hole filter. Reduce this filter to soma values between 0 and 5% in your case and it will look much better.

I am not sure what material your object has, but maybe some coating spray will help with scan quality.

 

For test purposes you can scan something white and matte.

I am an HP Employee

Original David Team Member
Honor Student
Posts: 3
Member Since: ‎01-15-2018
Message 5 of 6 (518 Views)

Re: Fusion-Problems with David SLS3 (HP 3D-)Scanner

 

Hello and thank you!
I still do not understand that, fill holes with 1%. smaller are only holes, bigger it gets worse.
It is a plastic part that I sprayed completely with white chalk spray.
I will try it now with gray plastic primer. White probably produces too many "highlights". There would probably be a soft light box, as you used when photographing, useful. This will make the light even in the room
distributed without creating "highlights" ...
But how does that work with the angles? Since I get nothing, no matter what I say at X / Y or Z or as an angle indicate ...
 
with regards,
 
Christian
Highlighted
Grad Student
Posts: 301
Member Since: ‎10-31-2016
Message 6 of 6 (511 Views)

Re: Fusion-Problems with David SLS3 (HP 3D-)Scanner

You are missing a lot of surface in your scans and software is trying to interpolate that because of the close holes filter. Try to take just a single scan and fuse it with close holes filter on 100%. You will get a clue what the problem is.

I am an HP Employee

Original David Team Member
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation