Post new question
Question
Reply
 
Intern
Posts: 59
Member Since: ‎11-05-2016
Message 1 of 1 (105 Views)

Optimize Multi Camera still buggy.

From the debug console: Horizontal open angle: 34.2714 Vertical open angle: 21.6624 Angle between calibration panels: 90 degree Optimizing Multi-Camera Calibration... Angle between calibration panels: 89.8398 degree Calibrate Projector. When Optimize is off David correctly reads the angle between the calibration panels and scanning in extended view and in stereo mode is accurate. When Optimize is enabled scans in extended view are distorted, but in stereo mode they are OK.
Reply
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation