05-09-2017 12:50 PM
I'm using HD 5.1 3d scanner with dual camera and convex calib board. currently I experiment some errors in some of my scans. sometimes a piece of scan jumps to a random space. and some times (more often) some spikes appear in scans.
Also edges of my scans are noisy and bended over, and this is a very big problem for me.
05-10-2017 03:31 AM
I am not sure what could be the cause in first case, but in second case it looks like there was some reflection during the scanning process.
Original David Team Member
06-05-2017 12:42 AM - edited 06-05-2017 12:47 AM
Hi again. these days I searched for error source and found that if I scan with dual cameras and in Stereo Mode, flipped edges and spikes are appeared, but by scanning in Extend Mode all spikes and flipped edges are removed.
In Extend Mode I've experienced mesh distortion and I can't align scans well, but in Stereo Mode Mesh distortion is very low and scans can be aligned.
Removing these spikes and edgesmanually is very hard and time consuming.
HP team must work hard on V5, it has major bugs and problems.
Scan in Stereo Mode:
in Extend Mode: