Showing results for 
Search instead for 
Did you mean: 
New member
4 1 0 0
Message 1 of 2
Flag Post

Sprout Pro G2 HP 3d scan bad calibration

HP Recommended
Sprout Pro G2
Microsoft Windows 10 (64-bit)



Got myself a Sprout Pro G2 for Christmas - but I'm unhappy with results. Partially because I have used David scanner many times before so I know what is broken.


My scans on Automatic turntable can not allign because each of them is distorted. The scan pairs does not fit and it looks exactly like a keystone distortion (If I put 100mm square object on the stage - the side that is close to me will be 103mm when measured - or simply 3mm larger then the side positioned closer to the monitor).


Well normally, I would just use a calibration V plates but there are none with Sprout G2.

So, what should I do?

I suppose I can set the projector and camera as a custom setup... but I have tried to put the calibration panel in and it would not work...also the largest one I have is 120mm and this seems to be too little for the Sprout Wide camera view.

Would you know on which size calibration panel the Sprout g2 can be calibrated?

Is there a way how to set the camera exposure for custom setup with Sprout?

Please let me know my options or any other information is appreciated.
Thank you.

Level 3
Level 3
52 51 4 5
Message 2 of 2
Flag Post
HP Recommended



Can you try printing out a 140mm scale printout for the panels and see if that works better?


To change the exposure, open WorkTools Control while OV580 is streaming. Hope this helps.

I am an HP employee
0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation