Post new question
Question
Reply
 
Highlighted
Top Student
Posts: 5
Member Since: ‎05-23-2017
Message 1 of 3 (867 Views)

"Automatic Turntable" does not take second Camera into account

Product Name: HP 3D Scan & Turntable
Operating System: Microsoft Windows 10 (64-bit)

Hi,

 

after adding a second camera to my setup and producing quite satisfying result with "Extended View", I tried some turntable scans at the weekend and found only one camera active.

 

What does the second camera do in a tuntable sequence? And how to determine wich camera is used in the scan when both are switched on?

 

Reply
0 Kudos
Grad Student
Posts: 196
Member Since: ‎10-31-2016
Message 2 of 3 (305 Views)

Re: "Automatic Turntable" does not take second Camera into account

In automatic turnable mode you are getting stereo scans. You are not able to scan in extended view mode.

That means only 3D points that are calculated from both sources (both cams) are shown as a scanning result.

I am an HP Employee

Original David Team Member

**Views expressed are my own**
Grad Student
Posts: 196
Member Since: ‎10-31-2016
Message 3 of 3 (301 Views)

Re: "Automatic Turntable" does not take second Camera into account

I wrote reply long time ago, but for some reason it was "auto saved content" and not posted. Maybe I forgot to press "Post". Man Surprised

I am an HP Employee

Original David Team Member

**Views expressed are my own**
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation