Jason-B Student
Student
1 0 0
Message 1 of 2
608
Flag Post

re-loading version 3

David
Microsoft Windows 7 (64-bit)

I just recently upgraded to a solid state hard drive and wanted to use my David scanner software. I have not used it in quite a while. I plugged in the dongle and went to the website to download the software and found a note that said

"Note: This product is out-dated - Please use DAVID 4."

So I downloaded version 4 and tried to start it and it asked me for upgrader information. Do I need an upgrade code to run my software? I filled out all the info except for the upgrade code because I do not have one. I do not wish to purchase anything more for this software, I only wish to use it on my new system. Please advise.

Thank you

Jason-

1 REPLY
Highlighted
Grad Student
Grad Student
317 19 31
Message 2 of 2
512
Flag Post

re-loading version 3

Upgrade from V3 to V4 is not cost free, but it is also doscontinued. To my knowledge V3 shuold work without any problems. You can try to download it from here:

http://www.david-3d.com/en/support/downloads

I am an HP Employee

Original David Team Member
Reply
0 Kudos
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation