cancel
Showing results for 
Search instead for 
Did you mean: 
wizzx
Level 1
9 2 1 0
Message 1 of 3
195
Flag Post

Solved!

After installing new graphic it won’t turn on

HP Recommended
Hp compaq pro 6300 sff
Microsoft Windows 10 (64-bit)

After putting in my graphics card my PC won’t turn on and I don’t know what to do I also I went on my bios to turned off secure boot but it still doesn’t turn on my bios version is Hewlett-Packard-packward ko1 v3.04, 10/5/2016

1 ACCEPTED SOLUTION

Accepted Solutions
wizzx
Author
Level 1
9 2 1 0
Message 3 of 3
Flag Post
HP Recommended

I have the GeForce 1030 msi low profile and my pc is new And also this  my first graphic card on this pc 

View solution in original post

Was this reply helpful? Yes No
2 REPLIES 2
banhien
Level 19
Level 19
94,663 93,320 12,269 26,099
Message 2 of 3
Flag Post
HP Recommended

@wizzx 

 

What is the video card ?  bios version is Hewlett-Packard-packward ko1 v3.04, 10/5/2016 only supports lower end cards. Also please check: Does its PSU have enough juice (wattage) to run new card ?

 

Regards.

BH
***
**Click the KUDOS thumb up on the left to say 'Thanks'**
Make it easier for other people to find solutions by marking a Reply 'Accept as Solution' if it solves your problem.




>
Was this reply helpful? Yes No
wizzx
Author
Level 1
9 2 1 0
Message 3 of 3
Flag Post
HP Recommended

I have the GeForce 1030 msi low profile and my pc is new And also this  my first graphic card on this pc 

View solution in original post

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation