cancel
Showing results for 
Search instead for 
Did you mean: 
Enklit
New member
2 1 0 0
Message 1 of 3
317
Flag Post

Desktop stuck in a HP blue screen after BIOs update.What do I do?

HP Recommended
HP Compaq DC7800
Microsoft Windows 7 (64-bit)

Hey so I was updating my BIOs and everything went perfectly fine.When I turned on my pc this morning the HP blue screen logo was looping over and over again.

 

I decided to reset my BIOs and then changed the date,but the problem is not solved!

Can you guys help me out?

2 REPLIES 2
DGroves
Level 11
4,714 4,684 445 995
Message 2 of 3
Flag Post
HP Recommended

a blue screen boot loop is a windows software error and i doubt a bios update caused this unless you perhaps had the bios settings changed/reset

 

in the bios make sure the boot drive is listed and is set to the primary boot device and that Raid/AHCI or Just AHCI mode is enabled

 

try booting in safe mode

 

also check the windows log files

 

if all else fails, reset bios to factory defaults and reload windows

Was this reply helpful? Yes No
Enklit
Author
New member
2 1 0 0
Message 3 of 3
Flag Post
HP Recommended

Hello!Thanks for the fast reply.

To be clear my pc wont start windows,its stuck in a infinite loop on the HP blue screen.I have tried many times to boot into safe mode but the option to do so isn't even shown.I cannot access Windows Log files because I cannot access windows.

I tried to do everything you recommended,but still no result.

I reseted my BIOs,changed the date as asked to boot,but the problem is still there.

If this is a windows software problem,should I format it?

 

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation