• ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
  • ×
    Information
    Need Windows 11 help?
    Check documents on compatibility, FAQs, upgrade information and available fixes.
    Windows 11 Support Center.
  • post a message
Guidelines
Are you having HotKey issues? Click here for tips and tricks.
Locked

‎01-15-2020 08:09 AM

HP Recommended
Product: HP Engage Flex Pro Retail System
Operating System: Microsoft Windows 10 (64-bit)

Hi,

 

How to set a 2x512Gb SSD  RAID 1 on HP Engage Flex Pro Retail System ?

 

BIOS\Advanced\System Options\Configure Storage Controller for RAID is checked

BIOS\Advanced\System Options\POST Prompt for RAID Configuration is checked

 

But no RAID configuration menu access on boot...

 

Thank you for help.

 

 

1 ACCEPTED SOLUTION

Accepted Solutions

‎01-17-2020 08:58 AM

HP Recommended

Hi,

 

On this HP system the CTRL-I isn't prompted.

After enabling the RAID option in the BIOS,  RAID management must be done under OS with the Intel RST utility.

My RAID 1 is now ready 😁

 

 

View solution in original post

Was this reply helpful? Yes No
2 REPLIES 2

‎01-16-2020 02:16 PM

HP Recommended

on most HP systems, after enabling the raid option in the bios you need to then select the drives to be used once the drives are selected the bios saves this config information in the cmos settings and also on the selected drives

 

The RAID Setup Utility can be accessed through CTRL-I during the boot sequence when prompted

 

once this low level config/setup of the drives is finished, the system and OS install should see the raid drives as a single device

 

more information should be available in the user manual

 

https://support.hp.com/us-en/product/hp-engage-flex-pro-retail-system/22488598/manuals

 

https://www8.hp.com/h20195/v2/getpdf.aspx/c06102173.pdf

 

Was this reply helpful? Yes No

‎01-17-2020 08:58 AM

HP Recommended

Hi,

 

On this HP system the CTRL-I isn't prompted.

After enabling the RAID option in the BIOS,  RAID management must be done under OS with the Intel RST utility.

My RAID 1 is now ready 😁

 

 

Was this reply helpful? Yes No
Warning
Be alert for scammers posting fake support phone numbers and/or email addresses on the community.
If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation.
Didn't find what you were looking for? Ask the community
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the <a href="https://www8.hp.com/us/en/terms-of-use.html" class="udrlinesmall">Terms of Use</a> and <a href="/t5/custom/page/page-id/hp.rulespage" class="udrlinesmall"> Rules of Participation</a>.