cancel
Showing results for 
Search instead for 
Did you mean: 
The HP Calculator Community Message Board is moving. While we prepare for the move, we are unable to accept new postings. During the move, you can look for help from other users by visiting https://www.hpmuseum.org/ . Or if you need technical support for your calculator visit: HP Calculators. .
TrevorThreeLink
New member
1 0 0 0
Message 1 of 2
334
Flag Post

HP Z230 Windows 7 stuck in startup repair cycle, unable to boot into safe mode - option missing

HP Recommended
HP Z320 Workstation
Microsoft Windows 7 (64-bit)

Good Morning,

 

Can someone help me. I have a HPZ230 workstation with Windows 7 that keeps cycling in start-up repair at boot and fails. I have carried out a hard drive check and it's passing SMART and short checks. I am trying to boot into safe mode but F8 does nothing and when I press escape to bring up all the list of startup options Safemode/F8 isn't mentioned. Is there any way to get into safemode on these machines at boot, or does anyone have any advice to I can fix this issue and get Windows booting up properly again?

 

Many thanks!

 

Trevor

1 REPLY 1
DGroves
Level 11
4,757 4,036 449 925
Message 2 of 2
Flag Post
HP Recommended
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation