cancel
Showing results for 
Search instead for 
Did you mean: 
gauguin16
New member
2 1 0 0
Message 1 of 4
279
Flag Post

HP Z620 BIOS configuration problem with 1 X SSD Sasmung(256GB) + 1 X SATA Disk(2TB)

HP Recommended
Intel C602 chipset, Intel Xeon processor E5-2650 product family
Microsoft Windows 10 (64-bit)

Hi,

 

Can someone give me a tip how I set in BIOS for 1 X SSD Sasmung(256GB) + 1 X SATA Disk(2TB).

I don't use UEFI boot sources, just Legacy boot source. It means the UEFI is disabled.

 

It runs Windows 10 OS on the SSD Sasmung(256GB) and SATA Disk(2TB) for data storage.

The problem is, wenn I just boot with only  SSD Sasmung(256GB) disk, it works (windows 10 running), but it doesn' work with both disks.

 

Please let me know if you have any questions?

 

Regards,

gauguin16

3 REPLIES 3
DGroves
Level 11
4,508 4,491 411 944
Message 2 of 4
Flag Post
HP Recommended

please check the boot order in the bios, the SSD must be above the entry for the mech drive

0 Kudos
gauguin16
Author
New member
2 1 0 0
Message 3 of 4
Flag Post
HP Recommended

Hi,

 

At first, thank you for your answer.

I set it the boot order to start the SSD in the bios. 

As spoken it just works good with only SSD disk, but not with both disks.  

And error message is "system not found" and "reboot again".

 

 

0 Kudos
DGroves
Level 11
4,508 4,491 411 944
Message 4 of 4
Flag Post
HP Recommended

please post a picture of your bios boot order

0 Kudos
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation