Showing results for 
Search instead for 
Did you mean: 
New member
1 0 0 0
Message 1 of 1
Flag Post

No boot -- hard disk - (3F0)

HP Recommended
Example: Thin Client t630
Microsoft Windows 10 (64-bit)

I had the problem "boot device not found" and the following was the solution .. the power cable was not correctly connected to the power supply .. the thin client still had voltage because it was shown graphically that the hard disk is not recognized .. after the plug the power supply (230VAC side) has rebooted and the thin client is working properly again .. I tried that with another thin client, it didn't happen, but when I used the power supply with the first one had not booted, the same thing happens again on another thin client .. I think the power supply is defective.

Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation