Removing Z1 Stand

[stevekna]

I would like to wall mount my Z1. Documentation says removing the stand reveals the VESA mounting holes yet I haven't been able to find instructions on how to remove the stand. It isn't obvious by looking at it. Can anyone advise me on how to remove it?

[David_Schwartzs · Accepted solution]

Go to this link:
http://h20464.www2.hp.com/results.htm?SID=5230510&MEID=CF99B2F6-4C11-4887-BFD6-0B572A33FC4C

Click on "Stand" on the left side. A video will walk you through.

Hope this helps, let me know if this does!

[stevekna]

Thank you, that was exactly what I was looking for. Regards.

[aeneas1]

went through the same thing, couldn't figure out how to access the vesa plate, the mentioned vid made me feel pretty silly, a snap to get to the plate once you know how it'sdone. fwiw i tried mounting my z1 to a doublesight articulating arm rated for the z1's weight, and it was a disaster, the arm was a piece of junk, didn't stand a chance against the z1, tension screw holes easily stripped when tightening, the pivot plate was too loose, absolute a piece of junk, ended up having to throw the arm out given the retrurn window had expired. decided to re-mount the z1 to it's original stand and, this time around, figured out how to better manage the stand's position mechanism (sat too close to my desk the first tme around, couldn't seem to get it to sit higher with out it wanting to slowly lower due to gravity). anyway, very happy with the stock stand now....

[olivero]

I am having the same problem with my stock stand, the monitor tends to sag doe to gravity...did you figure out how to solve this problem?

[KUEI12]

How did you adjust the tension of your HP stand? One of mine is also sagging 😞