cancel
Showing results for 
Search instead for 
Did you mean: 
The HP Calculator Community Message Board is moving. While we prepare for the move, we are unable to accept new postings. During the move, you can look for help from other users by visiting https://www.hpmuseum.org/ . Or if you need technical support for your calculator visit: HP Calculators. .
logfile
New member
1 0 0 0
Message 1 of 2
1,725
Flag Post

WOL Settings for Pro Desk 600 G1

HP Recommended
Pro Desk 600 G1
Microsoft Windows 10 (64-bit)

Hi Community,

 

I try to activate the wake on lan settings on our Pro Desk 600 G1. Yet I can't see it in the BIOS.

 

The WOL Seem to work for about 20 seconds after shut down. After that it doesn't do anything.

 

Does anyone has an Idea where I can change those settings in BIOS?

 

 

best regards,

L0gfile

1 REPLY 1
TryToDoMybest
Level 8
972 917 91 180
Message 2 of 2
Flag Post
HP Recommended

Hello

 

try in Device Manager

select the LAN card

open Proporty

check for Power management tab and enable "Allow this device the wake the computer"

 

bye

 

 

Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation