cancel
turn on suggested results
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
Locked It has been a while since anyone has replied. Simply ask a new question if you would like to start the discussion again.
Stefan_Wolfrum
Level 2
29 17 1 1
Message 1 of 1
478
Flag Post

Prime Connectivity Kit [macOS] crashes always

‎08-11-2020 10:19 AM

HP Recommended
Product: HP Prime G2
Operating System: macOS 10.15 Catalina

I'm on macOS (latest Catalina 10.15.6), Hp Prime Connectivity Kit 2.1.14425 (2020 1 16) and have a Prime G2 (Hardware D) with Software 2.1.14433 (2020 01 21), Operating System V2.060.650.

The Prime is connected via a microUSB to USB-C cable which served me well for a long time and indeed has worked fine in this setup.

However, currently I have the following problem: 

  • The Prime is connected.
  • I start the Connectivity Kit app on the Mac.
  • The Prime is listed and the Monitor panel shows its screen.
  • As soon as I click on the disclosure triangle to the left of the Prime where it is listed in the Connectivity Kit the Prime crashes with the message "Your HP Prime had a problem and will reboot in 3 seconds".
  • Which it does – but as soon as it comes back to its Home screen, after another 3-4 seconds, the Connectivity Kit crashes.
  • This happens always.

Are there newer versions available? The Connectivity Kit doesn't report/find newer app/firmware versions.

 

Any advice?

 

Thanks a lot!

Stefan.

 

0 Kudos

Didn't find what you were looking for? Ask the community

† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation