cancel
Showing results for 
Search instead for 
Did you mean: 
Get help with Large Format Printers, with direct access to all Latex Knowledge Center · Ask anything · Find anything · Share anything at HP LKC
Rantz
New member
1 0 0 0
Message 1 of 2
245
Flag Post

14.03:00

HP Recommended
L26500
Microsoft Windows 10 (64-bit)

14.03:00 is not listed in the Front-panel error messages. Listed as IO error. Anyone recognize this code?

1 REPLY 1
rasheddul
Level 7
634 609 35 85
Message 2 of 2
Flag Post
HP Recommended

Current too high on the Curing Module. Overcurrent in Curing Module. The level of amps is over 18 amps, or the amount of current requested from the curing Module is too high.

 

Please proceed: Check if there is an AC voltage surge from the customers electrical supply.

• Replace the heaters in the Curing Module, replace .

• If the level of AC voltage is normal, replace the Heater Control Assembly.

 

I hope it will help to you.

 

Regards/Rashed

Regards/Rashed
https://www.linkedin.com/in/rasheddul
Was this reply helpful? Yes No
Warning Be alert for scammers posting fake support phone numbers and/or email addresses on the community. If you think you have received a fake HP Support message, please report it to us by clicking on "Flag Post".
† The opinions expressed above are the personal opinions of the authors, not of HP. By using this site, you accept the Terms of Use and Rules of Participation